 |
GitDirt.com | |
Calculators | |
Racing Photos | |
Race Car Setup | |
|
GitDirt.com | |
Calculators | |
Racing Photos | |
Race Car Setup | |
| GM Powerglide Automatic Transmission Ratios |
|||||||||||
| The length of the input shaft can be measured
to determine the ratio. The input shaft
must
be pulled out to measure. It is best to stand transmission up on its tail to remove and replace the input shaft. TIP: The input shaft inserts into a bronze thrust washer inside the transmission. Make sure this washer is centered and not slid off to one side before replacing input shaft.. |
|||||||||||
|
|||||||||||
|
Copyright 2009-2010 Steve Henry Racing Lubbock Texas |
|||||||||||